Debugging Commands
Table 1 summarizes the available debugging commands. The descriptions assume that the command is being applied to a single thread, the thread in focus. In fact, debugging commands are much more flexible than this. They can apply to threads, processes, or groups, or some collection of these. Select the different scopes for debugging commands from the menu on the left of the toolbar, or by selecting the commands from the Thread, Process, and Group menus.
See Related Topics below for the location of discussions about these extended capabilities.
Command | Description |
|---|---|
Go | Sets the thread to running until it reaches a stopping point. Often this will be a breakpoint that you have set, but the thread could stop for other reasons. |
Halt | Stops the thread at its current execution point. |
Kill | Stops program execution. Existing breakpoints and other settings remain in effect. |
Restart | Stops program execution and restarts the program from the beginning. Existing breakpoints and other settings remain in effect. This is the same as clicking Kill followed by Go. |
Next | Moves the thread to the next line of execution. If the line the thread was on includes one or more function calls, TotalView does not step into these functions but just executes them and returns. |
Step | Like Next, except that TotalView does step into any function calls, so the thread stops at the first line of execution of the first function call. |
Out | If the thread is in a block of execution, runs the thread to the first line of execution beyond that block. |
Run To | If there is a code line selected in one of the Source views, the thread will stop at this line, assuming of course that it ever makes it there. This operates like a one-time, temporary breakpoint. |
Controlling the scope (width) of debugging commands | |
Controlling what happens when a thread reaches a breakpoint (action point) | |
Seeing the debugging commands in action |
